I rcently got in some hardware to use for the signals so thought I’d give them a test.  Here’s the Signal Bridge on the lower level in front of the refinery.

Everything worked as planned.

And look at how I’m wiring them:

A CML Electronics SIGM 20 in the wiring panel is connected to RJ 12 6P6C surface mount boxes.  An RJ12 conductor cable is then connected from that box to another surface mount box at the signal.

There I’m using a Cat5 8P8C surface mount because these were the only ones I could find that had screw terminals instead of punch down terminals.  Wires from the signal LEDs are secured to the approprate terminal.  With only 6 wires used here, I probably could have doubled up the signals on one wire/connection like I will do for the double targets, but oh well.

Shaun Previous Layout